Reach us

Doors

Veneer Skin Door

AK/Apple Veneer Skin Doors

AK/Apple Veneer skin doors are made of natural teak veneer in different colours and shades to meet the requirements of clients with diverse tastes & tasks. Due to the authentic raw material used, these skin doors can resist any types of stain & scratches and it offers the same allure of natural wood doors. We use 100% borer resistant vacuum pressure treated (VPT) finger jointed frames - a remarkable feature of these doors. The door offered by us is made as per the set industry norms keeping in mind the requirements of our clients. A huge range of size & thickness is available according to customer needs while they are also available in combination with glass panels.

Features

  • Panel sizes A range of sizes are available according to customer needs.
  • Thickness Common thickness range from 25mm to 45mm.
  • Bond/Adhesive Phenol formaldehyde (PF) for weather and Boil Water Proof (BWP) and low formaldehyde formulation for compliance to emission level requirements such as E1.

1) Dimensional stable core signifying enhanced strength and extra durability.
2) Its frames provide strength for fitting of hinges and anti deviation resistance.
3) Chemically treated to resist borer and termite attack.
4) Kiln dried to resist moisture, warping and to avoid twisting.
5) Manufactured to suit local climate and ready onto fix doors.
6) Excellent strength, stiffness impact resistance
7) Unique dimension stability
8) Superior finish.

Advantages of Finger Joint: (As per BIS Specification)

Finger jointing results in higher quality and stronger pieces and components, while dramatically reducing waste in the industry. By using finger joints, it is possible to produce pieces of sawn timber that are made completely of heartwood, knotless and very straight. The most important advantages of finger joint wood are straightness, dimensional stability, and the end product is always of premium quality.

Installations & storage guidelines for Flush door-

1) Deliver doors to the building site after the plaster, drywall and/or concrete dries.
2) Stacking of flush doors are recommended to be in a horizontal position on a flat floor in a clean, dry, well-ventilated building; the doors shall be kept away from direct sunlight and source of extreme heat, cold or humidity. Do not lean on the doors vertically against a wall or other structure.
3) If the doors are being stored at the job site and not for immediate installation, the top & bottom sides must be sealed.
4) Flush doors should not be trimmed by more than 10mm at any of its edges.
5) Locks should be placed at exactly the place shown by the sticker, immediately after the installation.
6) The gap between the frame and door shall be 3mm.
7) Polish/paint or laminate on door surface is recommended to be on both sides and with same characteristics material only, to avoid warpage later on.

DFW-520
DFW-530
DFW-540
DFW-580
DFW-590
DFW-600