Lami Door plain | AK Plywood

Doors

Lami Doors (plain Series)

Lami Doors (Metal Series)

Moulded Skin Door

Moulded Skin Door - Masonite

Veneer Groove Door

Veneer Moulded Skin Door

Veneer Skin Door

Fire Retardant Door

Particle board Flush Door

AK/Apple Lami Doors (plain Series)

AK/Apple Laminated doors are pressed with high-pressure laminate sheets which give them a unique distinction. In our collection, we use different types of laminate panels to create many different aesthetic results. Laminate is a thin sheet of scratch-proof synthetic material reproducing wood pattern, grain colour and pores. We can provide any laminate that the customer desires, as we have an intricate and wide supply network. We use only 100% borer resistant vacuum pressure treated (VPT) finger-jointed frames - a remarkable feature of these doors. The door offered by us is made as per the set industry norms keeping in mind the requirements of our clients. Doors are available in a range of size & thickness and also in combination with glass panels.

Advantages of Finger Joint: (As per BIS Specification)

Finger jointing results in higher quality and stronger pieces and components, while dramatically reducing waste in the industry. By using finger joints, it is possible to produce pieces of sawn timber that are made completely of heartwood, knotless and very straight. The most important advantages of finger joint wood are straightness, dimensional stability, and the end product is always of premium quality.

Installations & storage guidelines for Flush door-

1) Deliver doors to the building site after the plaster, drywall and/or concrete dries.
2) Stacking of flush doors are recommended to be in a horizontal position on a flat floor in a clean, dry, well-ventilated building; the doors shall be kept away from direct sunlight and source of extreme heat, cold or humidity. Do not lean on the doors vertically against a wall or other structure.
3) If the doors are being stored at the job site and not for immediate installation, the top & bottom sides must be sealed.
4) Flush doors should not be trimmed by more than 10mm at any of its edges.
5) Locks should be placed at exactly the place shown by the sticker, immediately after the installation.
6) The gap between the frame and door shall be 3mm.
7) Polish/paint or laminate on door surface is recommended to be on both sides and with same characteristics material only, to avoid warpage later on.